Typical Application - Kongskilde RVS 5000 S3 CR 50 Hz IEC Manual El Operador

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

This user manual applies to the Kongskilde

RVS Separator model RVS 5000, 10000 and 20000

Preface:

This users manual has been prepared in accordance

with EU-directive 2006/42/EC (Machinery Directive).

Marking:

See enclosed Declaration of Conformity.

Description:

The product is a separator designed to separate con-

veying air and paper, cardboard or plastics. The sepa-

rator is driven by and directly coupled to an electric

geared motor. The rotor in the separator is attached to

the shaft of the geared motor, the momentum is trans-

ferred to the separators housing via a momentum arm,

and connected to a flanged bearing at the opposite

end.

The rotor is supplied with replaceable rubber blades.

Material &

conveying

air inlet

Specifically for ATEX versions:

The separator is equipped with explosion relief valve,

brush shoe and ground straps, to prevent any hazards

related to dust explosions.

The explosion valve will discharge any explosion in a

controlled direction, and reduce or eliminate any flame

formation by means of an integrated flame arrester. A

sensor is mounted onto the explosion valve, allowing

for an activation signal to the plant control unit. Hence

it is possible to monitor any occuring dust explosions,

and take preventive action.

The brush shoe is installed at the end of the gear,

eliminating any sparks that would occur between rotor

and housing due to static discharge.

Ground straps are fitted to equalize the potential of all

main parts of the separator, to avoid any statical elec-

tricity build-up.

The separator is approved for Zone 21 internally, and

Non-zone externally.