Replacement Parts - Omega Lift Equipment 92450 Manual De Instrucciones

• Read, understand, and follow all printed materials provided with and on this product before use.
• Do not exceed rated capacity! Rated capacity is 450 lbs. (includes user, tools, equipment and personal items).
• Sit down gently! Avoid shock loads caused by jumping or falling onto seat.
• Do not stand on seat.
• Beware of pinch and crush hazards when folding and unfolding.
• Keep out of the reach of children! This device is not appropriate for children's use.
• Use on smooth, level surfaces only.
ASSEMBLY InSTRUCTIOnS
A Hex Key-Philips Screwdriver Combo Tool (J) is provided and should be the only tool needed to complete assembly.
1. Join frame sections by inserting front frame section (F) into channel sections of tool box subassembly (A). Line
up screw holes and thread screws (G) fitted with washers (D) into corresponding holes in channel sections. Do
not tighten screws yet.
2. Assemble a caster (E) and a tool tray (C or H) simultaneously. Position a caster stud into lower frame hole as
seen in Figure 1. Place tool tray into position by aligning the lower frame thru-hole with corresponding hole in
tool tray. Insert caster fastener into the swivel caster stud.
3. Repeat assembly above for remaining casters and tool tray. Once tool trays have been successfully installed,
hand tighten all assemblies with provided Combo Tool.
4. Ensure casters swivel and roll easily. Check Tool Box drawers for ease of movement. Store extra key in a secure
place for future use.
OPERATIng InSTRUCTIOnS
Understand and follow all warning information.
1. Load tool drawers carefully. Pull drawer open to remove, push to close.
2. After using a tool, wipe clean and dry before returning it to the tool box.
3. The toolbox seat is NOT suitable for storing flammable, combustible, or corrosive materials.
!
Keep hands away from pinch and laceration hazards points that are created during use! Be alert
and sober when using this product! Sit centrally on seat pad ONLY. NEVER sit on edge!
MAInTEnAnCE
Very little maintenance is required for this device. Wipe clean as needed. Use mild upholstery cleaner (not caustic)
to clean seat as needed.
!
Never add lubricant to casters!

REPLACEMEnT PARTS

Available Parts: Please refer to the Parts drawing when ordering parts. Not all components of the creeper are
replacement items, but are illustrated as a convenient reference of location and position in the assembly sequence.
When ordering parts, give model number, part number and description. Call or write for current pricing:
SFA Companies Inc. 10939 N. Pomona Ave. Kansas City, MO 64153, U.S.A. Tel:(888)332-6419 Fax:(816)891-6599
E-Mail: sales@omegalift.com Omega Website: http://www.omegalift.com
WARNING
!
To avoid personal injury and property damage:
(ref. Figure 1)
(Refer to Fig. 1)
3