Mestra IRIS 2 Manual De Instrucciones página 8

English
The Iris 2 Advanced vacuum mixer (R-080518) is used to make investmets, plaster and similar mixtures.
The machine has been designed as a simple and reliable tool for Dental Labs.
For optimum performance and a long service life, please read the instructions for use carefully.
- Read these instructions carefully before operating the unit. They contain very important
information about safety during the installation, operation and maintenance of the unit.
- Keep these instructions for further consultation.
- Check out the state of the unit upon unpacking it.
- Before connecting the device, make sure the voltage in the identification plate matches the
power source to be used. During the installation all the safety requirements must be
observed and the instructions of the manufacturer followed.
- The manufacturer will not be liable for the damage caused by an inappropriate grounding
system.
- Damage caused by a faulty installation or a wrong use of the unit is not covered by the
warranty.
- When in doubt, do not start the unit. Contact the supplier for questions or detailed information
about problems with the unit.
- Choose a solid well-leveled wall to place the mixer, and make sure that fixing bolts are firmly
screwed into the wall.
- Do not fit the bowl to the unit when the mixer motor is on. Make sure the blades-bowl set is
properly assembled.
- Wait for the motor to stop completely after finishing a cycle before removing the bowl.
- Do not touch the unit or the power cord with wet hands.
- Unplug the unit in case of storm and when you are not going to use it for a long time.
- Place the unit in a dry place, away from dust and water splashes.
- Do not pull, twist or fold the power cord excessively.
- Do not wet the unit; do not use chemical products to clean it.
- WARNING: to prevent electric shock hazards, connect the unit to a proper power source
(grounded 230 V, 50/60 Hz).
- Do not allow children or non-qualified personnel handling the unit.
- Do not dismount, repair or modify the unit.
- Do not ever place or remove the tanks while the unit is in operation.
- Contact the supplier for questions or detailed information about problems with the unit.
8
GB