Eiko DTD-95/CO/850-DIM-GY-U Manual Del Usaurio

SAFETY PRECAUTION:
• Read instructions carefully before attempting to install fixture. Retain instructions for future reference.
• Disconnect power before installing or servicing. This fixture must be wired in accordance with the
National Electrical Code and applicable local codes and ordinances.
• All wiring should be performed by a qualified electrician. This fixture is for outdoor use and should not be
used in areas with limited ventilation or high ambient temperatures.
SPECIFICATIONS:
Model
DTD-95/CO/850-DIM-GY-U
DTD-140/B5/850-DIM-GY-U
INSTALLATION:
Surface Mount
1. Please see label on the fixture for specifications.
2. Use expansions bolts to secure the fixture on
mounting surface. (Fig 1 & Fig 2)
3. Connect wires into terminal; white wire to
"Neutral" terminal, black wire to "Live" terminal,
green wire to "Ground" terminal; and fix them with
wire connectors.
1
wire connector
L (Black)
EiKO Global, LLC • 23220 W. 84th St, Shawnee, KS 66227 • (P) 1-800-852-2217 • (F) 1-800-492-8975 • eiko.com
EiKO Canada • 81 King St, Barrie, Ontario L4N 6B5 • (P) 1-705-721-5189 • (F) 1-705-721-7855 • orderdesk@eiko.com
DTD - Dusk-to-Dawn w/Twistlock Photocell
Input Voltage
100-277VAC
100-277VAC
2
N (White)
G (Green)
INSTALLATION INSTRUCTIONS
Input Current
1.0A
1.0A
Surface Mount w/Arm
1. Connect wires; white to "Neutral", black to "Line"
and green to "Ground".
2. Put end of the mounting arm tube into the U-slot,
then fix the arm with two hex socket screws.
Please make sure the arm will not rotate. (Fig 3)
3. Fix clamp to the arm and ensure the arm will not
rotate. Installl the fixture to the wall with four
screws.
3.34" (84.9mm)
Watts Power Factor
80W
120W
G (Green)
3
N (White)
L (Black)
≥0.9
≥0.9