Troubleshooting Tips - Cafe CCP06BP Serie Manual Del Proprietário

Troubleshooting Tips... Before you schedule service
Problem
Beverage center does not
run
Beverage center compressor
runs frequently or for long
periods of time
Beverage center has an odor
Light does not come on
Vibration or rattling
Normal Sounds
TEMPERATURE AND MOISTURE
Beverage center is too warm
Beverage center is too cold
Moisture on exterior/interior
of the beverage center
49-1000491 Rev. 3
Possible Causes
Beverage center is unplugged.
Breaker is tripped or turned off/Fuse
is blown.
Normal when first plugged in
Warm or large amounts of drinks
added
Door is left ajar
Hot weather or frequent openings
Gasket is not sealing properly
Interior needs to be cleaned
Beverage center is unplugged.
LED light is burned out.
Beverage center is not resting firmly
on floor
It sounds like water is flowing from
the Beverage center
Humming or buzzing sounds
Cracking or clicking sounds
Temperature control is not set low
enough
Doors opened frequently or left open
Warm food drinks recently
Gasket is not sealing properly.
Temperature control is set too low
High humidity
Doors opened frequently or left open
Gasket is not sealing properly
What to Do
Plug power cord into power source.
Reset/Turn on breaker or replace fuse.
Allow 24 hours for the beverage center to cool
completely
This is normal
Ensure that door is not being held open by an item
This is normal to maintain constant temperature
during hot and humid days
Clean the gasket
Plug into power source.
Contact a qualified technician to replace the
burned out LED.
Refrigerant flowing in the lines will make this
sound when the compressor starts and stops.
The compressor and fans can make this sound. If
the beverage center is not level, the sound will be
louder.
The interior parts will make this sound as they
contract and expand in response to temperature
changes.
24 hours for the temperature to adjust
preventing door from closing
Allow time for drinks and beverage center to cool
Clean the gasket
Adjust temperature in the compartment to the
This is normal. Dry surface and adjust
temperature to slightly colder setting
preventing door from closing
Clean the gasket
17