VONROC S_LB502DC Traducción Del Manual Original página 8

EN
The following charger of the can be used to charge
these batteries.
CD802AA Quick charger
The batteries of the VONROC VPOWER 20V battery
platform are interchangeable with all the VONROC
VPOWER 20V battery platform tools.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN 50636-2-100;
it may be used to compare one tool with another
and as a preliminary assessment of exposure to
vibration when using the tool for the applications
mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work pat-
terns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. On/Off button
2. Battery
3. Battery unlock button
4. Upper tube
5. Lower tube
6. Battery LED indicators button
7. Battery LED indicators
8. Charger
9. Charger LED indicators
3. ASSEMBLY
Before any work on the power tool, remove
the battery.
The battery must be charged before first
use.
8
Inserting the battery into the machine (Fig. A, C)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (2) into the base of the machi-
ne as shown in Fig. C.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. A, C)
1. Push the battery unlock button (3).
2. Pull the battery out of the machine like shown
in Fig. C.
Checking the battery charging status (Fig. D)
• To check the battery charge status, push the
button (6) on battery shortly.
• The battery has 3 lights indicating the charge
level, the more lights that burn, the more char-
ge the battery has left.
• When the lights are not burning it means the bat-
tery is empty and must be charged immediately.
Charging the battery with the charger (Fig. D)
1. Take the battery (2) from the machine.
2. Turn the battery (2) to upside down position and
slide it onto the charger (8) as shown in Fig. D.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet and
wait for a while. The LED indicators on the charger
(8) will lighten up and show the charger status.
The charger has 2 LED indicators (9) which indica­
te the status of the charging process:
Red LED Status Green LED status
Off Off
Off On
On Off
• Fully charging the 2Ah battery may take up to
60 minutes.
Charger status
No power
Standby mode:
- No battery is
inserted or,
- Battery inserted
but charging has
finished
Battery charging in
progress
WWW.VONROC.COM