Product Maintenance - Fellowes AutoMax 200C Manual Del Usuario

ADvANCED PRODUCT FEATURES
SilentShred™ Technology
SilentShred™ noise quality
shreds without noisy disruptions.
SLEEP MODE OPERATION
Feature shuts down the shredder after 2 minutes of inactivity
WHEN IN SLEEP MODE
1
2
To get out of sleep, open or
lid and load paper
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

PRODUCT MAINTENANCE

OILING SHREDDER
All cross-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
*Carefully apply oil
Open lid
across cutters (do not
get oil in paper tray)
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator
will remain illuminated and the shredder will not operate for the duration of the recovery time.
Remove Paper: W hen illuminated, press reverse (
Bin Full: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36053.
Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.
* Shredder will not run when lid is open.
MISALIGNED PAPER
1
If paper is not shredding
through auto feed tray,
check position of paper.
4
Insert paper
3
Close lid. Press and
hold forward ( )
2-3 seconds
15
); open lid and remove paper.
2
Paper should be flat and
aligned with front of
paper tray.
Energy Saving Sleep Mode
Feature shuts down the shredder
after 2 minutes of inactivity
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: the paper detection sensors is located in the center of the paper entry).
TO CLEAN THE SENSORS
1
2
Turn off and unplug
Open lid
shredder
3
4
Locate Auto-start Dip cotton swab in
infrared sensor rubbing alcohol
5
Using cotton swab,
wipe away any
contamination from
the paper sensors