Installation - Hotpoint HCM9DMWW Manual Del Propietario E Instrucciones De Instalación

Preparing of Installation
Read these instructions completely and carefully.
Freezer Location
day-to-day use in a dry, well-ventilated room.
not maintain proper temperatures.
Level Freezer
Level the freezer from side to side and front to back
freezer if necessary.
Clearances and Ventilation
freezer and the wall. Leave room above the freezer to
open the lid.
away from freezer.
Lid Removal
CAUTION
LIFTING HAZARD
lifting.
CAUTION
HINGE SPRING UNDER TENSION
If it is necessary to remove the lid, follow these steps:
1. Remove the lower part of the hinge cover and then
remove the upper part.
49-60798-2
water or direct sunlight.
Be sure to install your freezer on a floor strong enough
to support it when it is fully loaded.
NOTE: It should not be necessary to remove the lid
during installation. If, for some reason, the hinges need
adjustment, call a professional service company..
sheets, tablecloths, etc. This reduces air circulation.
2. Open the lid to the maximum position. (The hinges are
loosest at this position.)
3. Remove the 4 screws from the upper part of the hinge
Cover
Lower Hinge
Cover
4. To reinstall lid follow steps in reverse. Tighten all
hinge screws but avoid over-tightening to prevent
stripping. Reinstall hinge covers.
Hinge Screws to
be Removed