Industry Canada Notice - Smanos DB-20 Guía Rápida

This device is slave equipment, the device isnot radar detection and not
ad‐hoc operation in The DFS band.
The device for operationin the band 5150‐5250MHz isonly for indoor use
to reduce the potential for harmful interference to co‐channel mobile
satellite systems;
The maximum antenna gain permitted for devices in the bands
5250‐5350MHz and 5470‐5725MHz shall be such that the equipment
still complies with the e.i.r.p. limit;
The maximum antenna gain permitted for devices in the band
5725‐5850MHz shall be Such that the equipment still complies with the
e.i.r.p. limits specified for point‐to‐point and non‐point‐to‐point
operationas appropriate; andthe worst‐casetilt angle(s) necessary to
Remain compliant with the e.i.r.p. elevation mask requirement set forth in
Section 6.2.2(3) shall be clearly indicated.
Users should also be advised that high‐power radars are allocated as primary users
(i.e. priority users) of the bands 5250‐5350MHz and 5650‐5850MHz and that these
Radars could cause interference and/ordamage to LE‐LAN devices.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environ ment. In order to avoid the possibility of exceeding the FCC
radio frequency exposure limits, Hum an proximity to the antenna shall not be less
than 20cm (8 inches) during normal operation.

Industry Canada Notice

This device complies with Industry Canada licence-exempt
RSS standard(s).
1. Operation is subject to the following two conditions:
this device may not cause interference, and
this device must accept any interference, including interference
that may cause undesired operation of the device."
2. Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
Noted: 5150‐5250MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite
systems