Toparc SPOOL GUN Manual De Instrucciones página 10

WARNING
• Welding torch shall be capable of delivering their rated output when the following environmental conditions prevail:
_ Range of the temperature of the ambient air:
During operation:-10°C to +40°C;
After transport and storage at:-25°C to +55°C.
_ Relative humidity of the air: up to 90% at 20°C.
• Do not use the cable to drag other heavy objects (eg. Wire feeder).
• Strictly prohibit acting the welding gun as tools for knocking and cracking.
• In order not to make the liner permanent distorted which increases the feeding pressure, keep the liner away from
bending while installation, returns to cooling system without air bubbles.
• Splash
Splashes easily damage the welding gun and affect the welding quality in the course of welding. So in order to avoid
feeding problems, unstable electric arc and reducing the effect of the shielding gas, please clear away the splashes in
the nozzles and contact tip in time.
If the nozzle is not cleared duly, the splashes would make the welding gun inside short circuit to burn the welding gun
spares.
Please use the grease to defense the splashes. Avoid beating the welding gun using solid objects to clear the spatter.
•Once finishing the welding process, Please clear the welding gun and keep it safe for the future use.
• If the welding gun is not used more than one week, please take out the liner from the welding gun to avoid that the
rust would prevent feeding wires.
• Whenever parts appeared worn, please change the new parts for security purposes and better welding quality.
• Under the following circumstances, make sure to take protective measures outside.
- The conditions of being in an environment with increasing hazard of electric shock.
- The condition of being near flammable surroundings.
- The condition of being near flammable products.
- The condition of being in heighted working position.
- The condition of being near ventilation.
- The condition of being in noisy environment.
- The condition of being in closed space.
10
12 Press buton
13 Handle assembly (1-12)
14 WFS Control knob
15 Potentiometer 10K Ω
Potentiometer 5k Ω
Potentiometer 1K Ω
16 Potentiometer housing
17 Deive roll 0.8
18 Press arm spring
19 Bushing
20 Bearing
21 Press arm bolt
22 Inlet guide
23 Press arm
SPOOL GUN
35 Contact tip 0.8 mm
Contact tip 0.9mm
Contact tip 1.0mm
36 Nozzle 12mm
37 Gun neck 180°
38 Internal gas hose
39 Front spring cable support
40 Cable assembly 4m
41 Back spring cable support
42 Back handle
43 Gun plug nut
44 Euro gun plug without control
Euro gun plug
45 7 pin connector
EN