Toparc SPOOL GUN Manual De Instrucciones página 9

EXPLOSIVE VIEW
• SPOOL GUN
No. Description
1
2
3
4
5
6
7
8
9
10
11
SPOOL GUN
Gun handle
Trigger switch
Block
Cover
Hanger hook
Spool shaft
Bushing resistance rubber
Location bushing
Adjusting nut
Locking screw
Hook
1. Spool cover button
2. Spool cover fixing screw (levo)
3. Spool
4. Hub tension nut
Grasp spool in one hand and turn while adjusting hub tension
nut. When a slight force is needed to turn spool, tension is
set. Do not avertighten.
5. Drive roll Tension Thumbnut
Turn on unit and check drive roll pressure by feeding wire
against a wood board or concrete surface ; wire chould feed
steedily without slipping. Adjust drive roll tension thumbnut
if necessary. Do not overtighten. Turn off unit. Close cover.
6. Gun neck clamping screw
Loosen gun neck clamping screw and remove head tube.
7. Wire feeding speed adjusting knob.
No. Description
24 Press arm chaft
25 Bracket
26 Motor and gear box (19 :1)
27 Gas connector
28 Wire feeder assembly
29 Conducting bar
30 Liner assembly
31 O-Ring 7.65x1.78
32 Conductor tube
33 Insulator
34 Diffuser C/W spring
EN
9