Maintenance - Southwest AS720 Manual Del Operador

Accesorio de recorte de gran alcance con eje recto
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING:
To prevent serious injury, never perform
maintenance or repairs while the unit is running. Always
allow the unit to cool before servicing or repairing the unit.
For gas-powered units, disconnect the spark plug wire to
prevent the unit from starting accidentally. For electric-
powered units, disconnect the unit from the power source
to prevent the unit from starting accidentally.
NOTE: Some maintenance procedures may require special tools or
skills. If you are unsure about these procedures, take the unit to
an MTD authorized service dealer.
REPLACING THE TRIMMING LINE
Only use the trimming line described in the Specifications section.
Other types of trimming line may cause the unit to overheat or fail.
WARNING:
Never use metal-reinforced line, wire, chain or
rope. These can break off and become dangerous projectiles.
1. Remove the old line from the cutting head.
2. Use a clean cloth to clean the surface of the cutting head.
3. Insert the ends of the line through the circular holes in the side
of the cutting head (Fig. 7). Push the line through the holes until
both ends protrude from the positioning tunnels (Fig. 8).
4. Pull the ends of the line until the line is tight against the cutting
head. Make sure the ends of the line are of equal length (Fig. 9). If
one end is longer than the other, push the longer end back
through the cutting head partway and pull the shorter end out. If
necessary, repeat this process until both ends are of equal length.
5. Press the exposed trimming line between the circular holes until
it lies flat against the cutting head (Fig. 9).

MAINTENANCE

Positioning
Tunnel
Line
9
Holes
Line
Fig. 7
Line
Fig. 8
Cutting Head
Line
Fig. 9
Cutting Head
Positioning
Tunnel
Line

Publicidad

Tabla de contenido
loading

Tabla de contenido