Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
•
Have any damaged or defective parts repaired or replaced by
an authorized repair agent.
•
Regularly check the power lead for damage. Replace the lead
if it is damaged or defective.
•
Never attempt to remove or replace any parts other than
those specified in this manual.
•
The appliance is designed for use with 12V negative ground
vehicle battery systems.
WARNING: Do not operate the appliance with
systems which have positive ground or a different
voltage
•
The cigarette lighter socket may not be live when the ignition
is off and/or the key is removed. If in doubt, consult your
vehicle's owner's manual for information regarding the
above.
•
Use only as described in this manual. Use only manufacturer's
recommended attachments.
•
Do not use the appliance near water. Do not immerse the
appliance in water.
•
Keep the motor draught away from your eyes and face.
SAVE THESE INSTRUCTIONS
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz .......................hertz
min .....................minutes
or DC ......direct current
...................... Class I Construction
(grounded)
.../min or rpm ... revolutions or
reciprocation per
minute
A .........................amperes
W ........................watts
or AC ...........alternating current
ASSEMBLY AND ADJUSTMENTS
Attaching Accessories (Fig. B)
•
Fit the appropriate accessory
of the flexible hose
9
•
Make sure the accessory is fully attached.
•
Fit the long end of the flexible hose into the nozzle
•
Make sure the flexible hose is fully in.
...................... Class II
Construction
(double insulated)
n o .......................no load speed
......................earthing terminal
.....................safety alert symbol
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
&
, on the short end
7
8
.
Fig. B
OPERATION
Connecting to the Vehicle's Power Supply
•
Make sure the auto vac is switched off.
•
Remove the cigarette lighter from its socket, if present.
•
Plug the 12V car connector
lighter socket or power source).
Switching On and Off (Fig. C)
•
To switch the appliance on, slide the on/off switch
forward to position 1.
•
To switch the appliance off, slide the on/off switch back
to position 0.
Fig. C
EMPTYING AND CLEANING
WARNING: Projectile/Respiratory Hazard:. Never
use the auto vac without its filter.
WARNING: The filters are re-usable and should be
cleaned regularly. Optimum dust collection will only
be achieved with clean filters.
NoTICE: The filter is re-usable, do not throw it away when
the product is emptied.
.
4
NoTICE: In order to keep the suction force optimized, the
filters must be cleaned regularly during use.
•
There are two methods of cleaning the bowl, a quick
empty method and a thorough clean method.
Emptying the Dust Bowl (Fig. D)
•
Press the nozzle release buttons
4
straight off.
•
Empty the contents of the bowl.
•
To replace the nozzle, place it back onto the auto vac
until it "clicks" firmly into position.
Español
into your car's cigarette
6
1
5
and pull the nozzle
13
Publicidad
Tabla de contenido
