Technical Assistance - Millipore Millex-GP Guia Del Usuario

8
Specifications for 0.22 µm Millex-GP Filter Unit
Materials
Dimensions
Temperature limit
Housing burst at 25 °C
Filtration volume
Hold-up volume
Connections
Sterilization method
Flow rate at 25 °C

Technical Assistance

For more information, contact the Millipore office nearest you. In the U.S., call 1-800-MILLI-
PORE (1-800-645-5476). Outside the U.S., see your Millipore catalogue for the phone number
of the office nearest you or go to our web site at www.millipore.com/offices for up-to-date
worldwide contact information. You can also visit the tech service page on our web site at
www.millipore.com/techservice.
Hydrophilic polyethersulfone membrane; acrylic housing
inlet to outlet 26 mm (1.02 in.)
diameter 33 mm (1.30 in.)
filtration area 4.52 cm
pore size 0.22 µm
45 °C (113 °F) maximum
150 psig (10 bar) inlet maximum
10 mL to 200 mL
≤ 0.1 mL after air purge
®
Female Luer-Lok inlet; male Luer-slip outlet
Gamma irradiation
Typical initial flow rate for water at 30 psig: 175 mL/min
2 2
(0.70 in )
www.millipore.com/millex