Led-Signals - CAME MR8204 Guia De Inicio Rapido

LED-SIGNALS

The ORANGE LED
fl ashes quickly.
The ORANGE LED
fl ashes 1 x.
1
The ORANGE LED
fl ashes 2 x.
2
The ORANGE LED
fl ashes 4 x.
4
The ORANGE LED
fl ashes 5 x.
5
The ORANGE LED
is on.
The RED LED fl ashes
quickly after an
assisted setup.
The RED LED
lights up
sporadically.
The GREEN LED
lights up
sporadically.
The LED is off.
The reaction of
the door does not
correspond to the
LED-signal.
SAFETY INSTRUCTIONS
The manufacturer of the door system is responsible for carrying out a risk assessment and installing the sensor and the door system
in compliance with applicable national and international regulations and standards on door safety and if applicable, the machinery directive 2006/42/EC.
Only trained and qualifi ed personnel may install and setup the sensor. The warranty is void if unauthorized repairs are made or attempted by unauthorized personnel. Avoid
touching any electronic and optical components.
Came S.p.A.- Via Martiri Della Liberta 15 - IT-31030 DOSSON DI CASIER (TV)
TEL (+39) 0422 4940 - FAX (+39) 0422 4941 - info@came.it - www.came.it
Came S.p.A. hereby declares that MR8204 is in conformity with the basic requirements and the other relevant provisions
of the directives 1999/5/EC, 2004/108/EC and 2006/42/CE.
Only for EC countries: According to the European Guideline 2002/96/EC for Waste Electrical and Electronic Equipment
(WEEE)
Original upon request.
-
BUY TO
A DIP-switch was changed
without confi rmation.
The sensor signals
an internal fault.
Irregularities in the
power supply
The sensor receives
not enough IR-energy.
The sensor receives
too much IR-energy.
The sensor encounters
a memory problem.
The sensor sees the door
during the assisted setup.
The sensor vibrates.
The sensor sees the door.
The sensor is disturbed by
lamps or another sensor.
The sensor is disturbed
by the rain.
The sensor is disturbed by
rain and/or leaves.
Ghosting
The sensor vibrates.
The sensor sees the door
or other moving objects.
-
SELL PRODUCT
1
Confi rm the DIP-settings by a long push on the
push button.
1 Cut and restore power supply.
2 If orange LED fl ashes again, replace sensor.
1 Check power supply.
Check wiring.
2
Use the 1 m prism if possible (accessory).
1
Check the angle of the IR-curtains.
2
Use a low energy prism if possible (accessory).
1
Check the angle of the IR-curtains.
2
1 Cut and restore power supply.
If orange LED lights up again, replace sensor.
2
1 Check the angle of the IR-curtains.
Launch a new assisted setup.
2
Attention: Do not stand in the detection fi eld!
1 Check if the sensor is fastened fi rmly.
Check position of prism and cover.
2
1
Launch an assisted setup and adjust the IR angle.
1
Choose the critical environment presetting (DIP 1+2).
1
Choose the critical environment presetting (DIP 1+2).
Choose the critical environment presetting (DIP 1+2).
1
Change radar antenna angle.
1
1 Check if the sensor is fastened fi rmly.
2
Check position of cable and cover.
Remove the objects if possible.
1
Change radar fi eld size.
2
Check connections to test output.
1
If your door controller is not able to test the sensor,
2
connect the red and blue cable to the power supply.*
Change the activation mode of relay R1 (DIP 4).
1