Polygroup SUMMER WAVES AP-01 El Manual Del Propietario página 2

1. Do not operate the pumps for more than 10 minutes. The Electric Pump is designed to fully inflate your inflatable within 3 minutes.
2. Never leave the pump unattended when power is on.
3. Close supervision is necessary when this air pump is used by or near children, invalids, or disabled persons.
4. Keep infant and small children away from this air pump when it is not in use.
5. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
6. Children should be supervised to ensure that they do not play with the appliance.
7. Use this air pump only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer.
8. Never operate this air pump if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water.
Return the air pump to a service center for examination and repair. Do not attempt to replace the cord.
9. Keep the cord away from heated surfaces.
10. Never operate the air pump with the air openings blocked. Keep the air openings free of lint, hair, and the like.
11. Never drop or insert any object into any opening.
12. For indoor use only. Do not use outdoors. Do not use or place this product near water.
13. For household / residential use only.
14. Keep this product away from sharp and pointed objects.
15. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
16. To disconnect, turn off the power switch, then remove plug from outlet.
17. After the inflatable is properly inflated and desired firmness is attained, always unplug the air pump.
18. Disconnect the air pump from the power supply before servicing.
19. Do not operate any air pump with a damaged cord or plug. Discard air pump or return to an authorized service facility for examination and / or repair.
20. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances.
Arrange cord away from traffic area and where it will not be tripped over.
21. SAVE THESE INSTRUCTIONS for future reference.
SETUP AND OPERATION INSTRUCTIONS
Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
1. Select a flat indoor surface large enough to accommodate the inflatable.
2. Remove all sharp and pointy objects on and near this surface.
3. Remove the air pump from the packaging.
4. Insert the nozzle that fits with the inflatable to the pump inflate outlet. (Fig. 1)
5. Lay the bottom of the inflatable on the selected surface.
6. Orient the inflatable properly.
7. To inflate the inflatable:
• Plug the cord to a household wall outlet of 110 to 120V.
• Push the power button to start the air pump. (Fig. 2)
• The inflatable will be automatically inflated.
• Turn off the air pump by pressing the power button.
• Unplug the cord.
8. To quick deflate the inflatable:
• Clean and dry the inflatable. See below, "Care, Storage & Maintenance."
• Insert the nozzle to the air pump deflate outlet. (Fig. 2)
• Plug the cord to a household wall outlet of 110 to 120V.
• Push the power button to start deflating the inflatable. (Fig. 2)
• The inflatable will be deflated automatically.
• Turn off the air pump by pressing the power button.
• Unplug the cord.
9. To reduce the risk of electric shock, this air pump has a polarized plug (one blade is wider than the other).
This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
10. Use only a 2-wire extension cord that has a 2-blade polarized plug, and a 2-slot receptacle that accepts the plug
on the product. Make sure your extension cord is not damaged. When using an extension cord, be sure to use one
heavy enough to carry the current your product draws. Do not use extension cords longer than 50 ft. The extension
cord shall be rated at least 300v , and with size no smaller than 18 awg, cord type shall be no lighter than SPT-2, such
as SVT, HPN, SJT are acceptable cord. Overheating, short circuit and fire damage will result from inadequate wiring.
2
Nozzles
Power
Button
Inflate
Nozzle
FIG.1
To Inflate
Deflate
Nozzle
FIG.2
To Deflate