Kalorik CMM 39732 Manual Del Usuario página 8

Fax +32 2 359 95 50
STORAGE
To store all the accessories and the unit cleanly and safely, please
proceed as follows:
Assemble the chopper, as explained in the paragraph "How to
•
use with the Chopper bowl".
Place the accessory holder (6), centred on the lid of the
•
chopper.
Place the motor block, as explained in the paragraph "How to
•
use with the Chopper bowl".
Place the whisk assembly on one of the domes of the accessory
•
holder, and lock it in place with a clockwise twisting motion.
Place the blending shaft on the other dome, and lock it in place
•
with a clockwise twisting motion.
To disassemble, proceed with reverse action and order.
•
Alternatively, you can hang the motor block with only the
•
blending shaft attached to it, using the hanging loop located
where the power cord meets the motor block.
NOTE: NEVER PUT THE MIXING CUP INTO THE MICROWAVE
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity. Print only what is inside the frame.
8
Assembly page 8/32
CMM 39732 - 120501