Publicidad
Idiomas disponibles
Idiomas disponibles
8
English / Français
Troubleshooting
Error
The battery LED working
light does not react when
the button is pressed
When used with the car
adapter, the battery-
powered LED worklight
does not function/does
not charge.
Maintenance
When used properly, the battery-powered LED worklight requires no maintenance. If the unit is dirty, it should
be cleaned with a dry cloth.
Repairs
Repairs may only be carried out by qualified persons and is subject to the decision of the manufacturer.
Never try to repair the product yourself. If there is any doubt as to its proper functioning, the battery LED
worklight must be removed from service for inspection by an expert.
Regular inspections
Perform a visual inspection before each use to detect any damage.
Damaged battery LED worklights or mains chargers must not be used.
Such use would cause a risk of injury from possible electric shocks.
Disposal
Electrical devices and accumulators must not be included in general household waste. Dispose of the worklight and accu-
mulators at an appropriate collection point at the end of their service life.
Warranty
The warranty expires if the product is used improperly and if the information in these operating instructions is not
observed. Further warranty provisions can be found in the General Terms and Conditions of ProLux Systemtechnik GmbH &
Co KG.
Français - Article n° 310 405
Sommaire
Original operating instruction - Akku-LED-Arbeitsscheinwerfer / Battery LED worklight
Cause
The battery of the battery-powered LED
worklight is completely flat
Defective fine-wire fuse in the plug of
the car adapter
Solution
Charge the battery with the included
mains chargers
Replace the defective fine-wire fuse in
the plug of the car adapter.
9
9
9
9
9
10
10
11
11
11
11
11
12
Publicidad
Capítulos
