Led Indicator; Important Safety Instructions - Urbanears Plattan ADV Manual Del Usuario

PLATTAN ADV WIRELESS USER MANUAL

LED INDICATOR

Status
Red (continuous)
White (continuous)
Blue (blinking)
White (blinking)
White (10s interval)
Off
TROUBLE SHOOTING
Problem
Not powering on
Not charging
Not pairing
No sound
Poor sound quality

IMPORTANT SAFETY INSTRUCTIONS

Set your sound source to low volume before using the headphones.
•
Do not use these headphones when operating a motor vehicle, a bicycle, or machinery or where your inability to hear outside
•
sounds may present a danger to you or others.
Using these headphones limits your ability to hear noises around you, regardless of listening volume. Please use caution when using
•
these headphones.
CLEANING THE HEADPHONES
Detach the washable headband and machine wash 30° C (Cold/Cool). Clean the
headphones with a soft, dry cloth. Note! Do not use liquids or sprays.
Indicates
Battery charging
Fully charged and connected to a USB power source
Pairing mode, waiting to pair
Waiting to connect
Connected and switched on
Headphones are switched off or in normal operation
Action
Charge the headphone using the USB cable.
Make sure the headphone is off before turning it on.
Make sure the USB power source is switched on.
The LED indicator is red while charging and white when fully charged.
Move the devices closer to each other and away from any interference or obstruction.
Make sure the headphone is not connected to a different sound source when entering the pairing mode.
Disable and enable Bluetooth® communication on your sound source.
Make sure the headphone is on and connected.
Make sure the sound source is playing.
Move the devices closer to each other and away from any interference or obstruction.
ENG