Jung FM 5232 Serie Instrucciones De Servicio página 6

eNet
Tecla persiana con receptor vía radio
Priority, lock­out protection
Priority, restraint
Priority, wind alarm
Priority, sun protection
Priority, twilight
Slat change­over time
Fabric­stretching time
Moving time
Minimum change­over­time
Invert movement direction
Operating hours up
32582603
J:0082582603
0...4
Basic setting: 1
0...4
Basic setting: 2
0...4
Basic setting: 3
0...4
Basic setting: 0
0...4
Basic setting: 0
0 ms ... 10 sec
300 ms ... 10 s
Basic setting: 0 ms / 300 ms
1 ... 600 sec
Basic setting: 120 s
300 ms ... 10 sec
Basic setting: 1 s
On, Off
Basic setting: Off
0...65535
Basic setting: Current value
6/8
Specifies the priority for reca­
lling and removing a scene of
type Lock­out protection for
the channel.
Specifies the priority for reca­
lling and removing a scene of
type Forced position for the
channel.
Specifies the priority for reca­
lling and removing a scene of
type Wind alarm for the chan­
nel.
Specifies the priority for reca­
lling and removing a scene of
type Sun protection for the
channel.
Specifies the priority for reca­
lling and removing a scene of
type Twilight for the channel.
Absolute time for changing­
over Venetian blind slats. The
fabric stretching time can also
be set here for the Awning
operating mode.
Absolute time which the
blind/shutter requires from the
top to the bottom end position.
The entry is essential if scene
or position movements are to
occur.
Minimum interruption time
when changing directions. In­
creasing the minimum chan­
ge­over time will cause less
wear on the motors.
Inverts the activation of the re­
lay outputs. During inverted
operation, the relay outputs
"Up" and "Down" should be
activated in reverse. This is re­
quired, for example, for con­
trolling skylights.
The time is counted during
which the load is physically
switched on (relay contact clo­
sed).
This parameter can be reset to
"0", for example after exchan­
ging the load.
The Reset button is used to
reset the counter to "0". The
device must be programmed
to apply the change.
13.03.2014