Garantía - Jung FM 5232 Serie Instrucciones De Servicio

eNet
Tecla persiana con receptor vía radio
Operating hours down
Information window
During channel selection in the Information window, the following settings can be made or va­
lues displayed.
Display value
Position value, venetian blind
Position value, slat
Restraint
Lock­out protection
Switching cycle counter UP
Total UP operating hours
Operating hours UP
Switching cycle counter DOWN
Total DOWN operating hours
Operating hours DOWN
i The value can be updated using the arrow next to the display values.
6.3 Accesorio
Se puede combinar con todos los mecanismos de control de motor del sistema de control de
persianas.
6.4 Garantía
Reservado el derecho a realizar modificaciones técnicas y formales en el producto, siempre y
cuando sirvan para adaptar el aparato a los avances técnicos.
Prestamos garantía dentro del marco de las disposiciones legales.
Le rogamos envíe el aparato franco de porte con una descripción del fallo a nuestro servicio
central de atención al cliente.
32582603
J:0082582603
0...65535
Basic setting: Current value
Explanations
The position value of the Venetian blind can
be changed.
The position value of the slat can be changed.
Display of forced position status.
Display of the lock­out protection status
Display of the switching cycles in the UP direc­
tion with the factor 10, e.g. the value 5 x 10 is
displayed for 50 switching cycles.
Display of the operating hours in the UP direc­
tion since the start of operation.
Display of the operating hours in the UP direc­
tion since the last restart in the Settings win­
dow.
Display of the switching cycles in the DOWN
direction with the factor 10, e.g. the value 5 x
10 is displayed for 50 switching cycles.
Display of the operating hours in the DOWN
direction since the start of operation.
Display of the operating hours in the DOWN
direction since the last restart in the Settings
window.
7/8
The time is counted during
which the load is physically
switched on (relay contact clo­
sed).
This parameter can be reset to
"0", for example after exchan­
ging the load.
The Reset button is used to
reset the counter to "0". The
device must be programmed
to apply the change.
13.03.2014