Publicidad
Idiomas disponibles
Idiomas disponibles
EN
DESCRIPTION OF COMPONENTS AND OPERATING INSTRUCTIONS.
PROBLEM
Wrong size rivet.
Had some filings jam in the jaw
Rivet is jammed
case.
Had some filings stick on the
nosepiece top.
Damaged o-rings.
Air leaking.
Loose screws.
Stroke length is not
Frame O-ring is damaged or
correct.
deformed.
Air feeding tube loose.
Tool runs slow or
has loss of power.
Operating pressure is too low. Increase the operating pressure to 85-95psi.
Rivet can't pull out
Hydraulic oil is not enough.
or no power.
CAUSE
The different rivets need to change the compared
nosepiece, jaw and jaw joint.
Use the adjustable wrench or spanner to disassemble
frame head.
Use spanner to disassemble jaw case.
Use blow gun to clean out filing; then smear the oil
on the parts.
It is often happened when pulling the aluminum
rivet.
Use the sharp thing (tool) to remove the filing.
O-rings need to be replaced.
Screws need to be tightened.
Frame O-ring has to be replaced.
Re-install and tighten the tube.
Open the cylinder cap and reload Hydraulic oil into
the tool.
9
REMEDY
Publicidad
