Connecting Power Cables - Axis PoE MIDSPAN 8-Port Manual Del Usuario

Page 10
Installation

Connecting Power Cables

The AC power cable is connected to the AC power connector located in the
rear side of the AXIS PoE Midspans 8P/16P and the power outlet.
Connecting Ethernet Cables
The ports in the product's front panel are configured as 'route through'
ports for all the eight/ sixteen RJ-45 connectors. Use Category 5 cabling in
making connections.
1. Connect cables from the ethernet switch to the data ports - on the
bottom row of the AXIS PoE Midspans 8P/16P.
2. Connect the cables from the IEEE 802.3af powered devices to the
corresponding Data and Power ports on the top row of the AXIS
PoE Midspans 8P/16P.
Powering Up
AXIS PoE Midspans 8P/16P are powered by the power cord. In order to
apply or remove power to or from the Midspan, connect or disconnect the
AC power cable to or from the AC power connector on the rear side of the
unit.
With AC power the unit starts-up and the internal fans are active. The
device runs through a quick power-on test, which takes less than 10
seconds. During this period, all ports are initially disabled and the port
indicators light up. The sequence of the port LEDs are shown in the section
below - LED Indicator. Ports now operate under normal conditions.
Installation