Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
QEP STK# 21600 JAMB & UNDERCUT SAW
INSTRUCTIONS CONTINUED
NOTE: ALWAYS feed the saw to
your RIGHT so the blade teeth
advance into the wood. If the saw is
moved to your left, it could result in
"kickback" and loss of control of the
saw, which can result in damage to
the material or personal injury. Move
the saw slowly and evenly through
the material. Hold the saw firmly and
keep it firmly on the floor as you cut
through the material.
REGARDING WOOD COVE BASE MOLDINGS
While some flooring installers trim wood cove base molding with jamb saws, it is not a
recommended practice.
Professional Flooring and Trade Associations recommend that the cove base molding be
removed then replaced after the new floor is installed. This results in a better looking
installation and preserves the height and appearance of the cove base molding. Should you
choose to trim the cove base with the jamb saw, be especially careful to avoid embedded
finishing nails.
Make sure you have a flat, even, smooth surface to support the saw base plate as you cut the
base molding. Never run the saw over carpeting or pad.
When cutting inside corners, you will generally need to use a chisel or utility knife to remove all
cove base material.
REGARDING DOOR TRIMMING
ALWAYS remove doors, and cut evenly with a table saw or circular saw.
SPECIFICATIONS
Motor Unit:
No Load Speed:
Arbor Diameter:
Blade Adapter Diameter:
Ball and Needle Bearings:
Blade:
Width of Teeth:
Saw:
Saw Assembly:
Height Adjustment Range:
Current:
110 Volt, 60 Hz
Amperage:
5.8 amps
10,000 RPM
5/8"
20mm
Weight:
5
1
⁄
4
Spiral ground gears
for smooth, quiet operation
Diameter:
4
1
⁄
4
Teeth:
20, carbide
.080 (approx 1/12")
Arbor Size:
20mm
Diecast and machined aluminum
3/16" to 1
Wall Board
lbs.
"
1
⁄
"
8
Cove Base
Move Saw
This
Direction
Only
Publicidad
Tabla de contenido
