Handling And Operation; Switching The Appliance On And Off; Maintenance; Changing The Light Bulbs - Silvercrest SEKU 2000 A1 Instrucciones De Uso

Handling and operation/Maintenance

Handling and operation

NOTICE
See also "Operating Elements" on page 67.
►
In this chapter you receive important information for the handling and operation of the appliance.
Activate the ON/OFF switch
♦
desired brightness with the Dimmer
Then, turn the heater on with the switch
♦
1 (1000 W).
Activate the additional switch
♦
Using the thermostat
♦
after reaching the set temperature range, and switch back on when it becomes cooler.
Switching the appliance on and off
Activate the ON/OFF switch
♦
Activate the ON/OFF switch
♦

Maintenance

The maintenance of the appliance is limited to occasional external cleaning.
NOTICE
Keep the appliance, and in particular the ventilation grille, free from dust and dirt.
►

Changing the light bulbs

DANGER
Risk of electrocution!
Contact with electricity can be fatal!
Pay heed to the following safety information to avoid the risks of injury:
Switch the appliance off .
►
Before changing the bulb, unplug the appliance from the mains power source.
►
WARNING
Risk of injury from sharp edges!
When reaching in through the housing opening, there is a risk of injury from the
sharp edges on sheet metal housing and the refl ector mirrors.
Pay heed to the following safety information to avoid these risks:
Do not touch the edges of the housing and the refl ector mirror
►
Wear protective gloves if necessary.
►
SEKU 2000 A1
to turn the unit on. The fl ame replication lights up. Programme in the
.
5
; the built-in fan starts to run and the heater is working at level
2
; the heating is now working at level 2 (2000 W).
3
, you can set it to the desired temperature. The heat settings switch themselves off
4
to turn the appliance on.
once again to turn the appliance off .
.
11
GB
MT
75