Maintenance; Notes - Truper ROU-N3 Manual Del Usuario

Maintenance

• Double-check the vent slots in the machine are free of sawdust, chips, etc.
• Keep the guides clean and lubricated with all-purpose light oil.
Service
• Service for the tools shall only be carried out in a Authorized Service Center.
• Service and maintenance carried out by non-qualified people may be dangerous and could cause personal injury. It also
makes the Warranty void.
Carbon brush replacement
• It is necessary to replace with new carbon brushes, worn (or burnt, broken or
smaller than 0.19" long carbon brushes).
• Anytime carbon brushes need replacement, always replace both carbons.
• Remove worn carbon brushes from the carbon brush housing and remove
accumulated dust with compressed air.
• Set the new carbon brushes reversing the order. Carbon brushes should
easily fall into the carbon brush housing.
• After setting the new carbon brushes, let the router running unloaded for a
Carbon brush cap
couple minutes to get a better adjust.
• Use only original spare carbons specifically designed
with the hardness and electric resistance adequate for each type of motor.
Carbons that are out of specification could damage the motor

Notes

9
ENGLISH