Southwire M555TP Instrucciones De Operación página 3

Probador de continuidad para cables de datos
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Tester Description
Cable Tester Top View
1. RJ45
Jack
2. TEST button
3. POWER LED
4. Detachable Remote
Detachable Remote
Bottom View
1. LEDs indicate the wiring
status of each pair on a
four pair data cable.
2. LED verifies shield integrity
on shielded cables.
Patch Cables
(Two included)
4-5
7-8
3-6
M555TP
TEST
POWER
T568A
T568B
4-5
7-8
3-6
5. RJ45 Jack
4-5
7-8
3-6
PASS
SHORT
REVERSAL
1.
2.
4-5
7-8
3-6
S
3
Operation
Testing a Data Cable Terminated with RJ45 Connectors
WARNING:
Never test a cable that is connected to live equipment.
Exposure to voltage can damage the tester.
Tester
1. Connect one end the cable under test to the RJ45 port on the tester.
2. Detach the remote from the bottom of the tester.
3. Connect the other end of the cable under test to the RJ45 port on the remote.
4. Momentarily press the TEST button.
5. If all four pairs on a data cable are properly wired,
the LEDs for each pair will flash green in the sequence
shown below:
1-2
3-6
If the LEDs flash out of the sequence, the wire pairs are miss-connected
at one end of the cable. If an LED does not flash or flashes red,
the corresponding pair is miswired.
Detachable
Remote
S S
4-5
7-8
4

Publicidad

Tabla de contenido
loading

Tabla de contenido