Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION
Read Rules and Instructions for Safe Operation
WARNINGS
1.
To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.
2.
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug
is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
3.
This appliance is not intended for use by children.
4.
Do not leave the fan running unattended.
SAFETY WARNINGS
1.
Fan should be used under rated voltage.
2.
Connect power only after the fan is fully assembled.
3.
Never insert fingers or any other object through the grill when fan is running.
4.
Unplug from outlet when not in use, when moving fan from one location to another, before putting on or taking off
parts before cleaning.
5.
Do not leave the fan running unattended.
6.
Keep children away from the appliance.
7.
This product is intended for household use ONLY and not for commercial, industrial or outdoor use.
8.
To protect against electrical shock, do not place fan in windows, immerse unit or cord in water or spray with liquids.
9.
Do not operate the fan in the presence of explosive or flammable fumes.
10. Do not place the fan or any parts near an open flame, cooking or other heating appliance.
11. To disconnect, grip the plug and pull it from the wall outlet. Never yank the cord.
12. Do not hang or mount fan on wall or ceiling.
13. Do not operate if the fan housing is removed or damaged.
PARTS NAME
1.
Front grille
2.
Blade
3.
Plastic nut
4.
Rear grille
5.
Motor shaft
6.
Oscillating Switch
7.
Fan Body
8.
Spinner
9.
Base
10. Speed control keys
11. Tight
12. Loose
BASE ASSEMBLY
1.
Detach screw from base of the fan.
2.
Match locking tab to base and click into position.
3.
Tighten the screw in the base to secure the fan to the base.
ASSEMBLY OF BLADE AND GRILLS
1.
Take the Spinner out from the bag and remove the plastic nut by turning it counterclockwise.
2.
Set the rear grill in the proper position with the handle up.
3.
Screw on plastic nut tightly to attach grill.
4.
Install the blade onto the shaft until the retaining pin fits into the notch on the blade.
5.
Screw spinner onto motor shaft counterclockwise.
6.
Mount the front grill and join both grills together using the clips.
7.
Remove and discard plastic sleeve on shaft.
3
1
2
4
10
11
12
8
5
6
7
9
1
Publicidad
Tabla de contenido
