Ecco EW3108-F Instrucciones De Instalacion Y Uso página 2

Installation (Pedestal Mount):
1. Attach the bolt through the hole and side bracket using
the spring locking bolt. See Figure 1.
2. Select a mounting surface to match the diameter of the
included bracket(s).
3. Put the shockproof pad on the mounting plate, then feed
the hexagon bolt through the side of the bracket. Put the
plain washers and locking spring washer on the bolt, then
fasten it. See Figure 2.
4. Connect the power line to the corresponding power
connector.
5. Adjust beam location of the unit and tighten the lock nut
with a wrench.
920-0406-00 Rev. D
Figure 1
Figure 2
Figure 3
Installation (Pivot Mount):
1. First, put hexagon bolt through movable bracket,
shockproof pad and the bracket, then fasten hex nut. See
Figure 3.
2. Put two finished brackets into the bottom of bracket round
bar, then adjust these two brackets in proper position, then
fasten it. See Figure 4.
3. Put hexagon bolt through bracket and mounting plate,
then put spring meson, then fasten nut. See Figure 5.
4. Connect the power line to the corresponding power
connector.
Figure 4
Figure 5
Page 2 of 9