Publicidad
Enlaces rápidos
INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION.
REGISTER BOOT
Note: Hardware NOT shown at actual size.
Replacement screws and anchors can be bought at major hardware stores.
HWGWTR-1 REAR REGISTER KIT
INSTALLATION INSTRUCTIONS
Package Contents
REGISTER WITH DAMPER
Hardware Package
#10 X ½" PHILLIPS HEX HEAD SCREW (10)
#10 X 1" SLOTTED HEX HEAD SCREW (2)
Tools Needed
FLAT SCREWDRIVER
TAPE MEASURE
SNIPS
HAMMER
PRIVACY SHIELD
PHILLIPS SCREWDRIVER
SAW
DRILL
Reverso en español
Page 1
Publicidad
Manuales relacionados para HouseWarmer HWGWTR-1
Resumen de contenidos para HouseWarmer HWGWTR-1
- Página 1 Reverso en español HWGWTR-1 REAR REGISTER KIT INSTALLATION INSTRUCTIONS INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION. Package Contents REGISTER BOOT REGISTER WITH DAMPER PRIVACY SHIELD Hardware Package Note: Hardware NOT shown at actual size. Replacement screws and anchors can be bought at major hardware stores.
- Página 2 Register outlet must be cut in wall before furnace is installed. There are two knock-outs on the inner casing of the furnace. On installed furnace, remove furnace in order to cut hole in wall 2. Remove outer knock-out (4 5/8" x 9 1/2") (117mm x 241mm) for register outlet.
- Página 3 HWGWTR-1 Assembly View and Parts List Insert register assembly within boot and secure register assem- bly to wall with (2) No. 10 x 1" (25mm) screws provided. Use pull chain to adjust damper in order to regulate heat dis- charge.
-
Página 4: Service Notes
SERVICE NOTES HOUSEWARMER is a registered trademark of Empire Comfort Systems Inc. Manufactured by: Empire Comfort Systems Inc. 918 Freeburg Ave. Belleville, IL 62220 PH: 877-459-1583 FAX: 877-459-0514 Page 4 23892-0-0807...