Operating Instructions; Loading And Actuating Instructions - Nitroset NTS8X Manual Del Usuario

Operating Instructions

Loading and Actuating Instructions

1.
Reset the tool before inserting the fastener to ensure the muzzle barrel is
clear of any debris.
A) Pull back front of muzzle until reset spring fully collapses.
B) Ensure firing pin guide clears all debris from muzzle chamber
prior to inserting new fastener assembly.
2.
Insert the fastener fully into the muzzle of the tool. Fasteners must be fully
seated in muzzle to ensure proper actuation.
(Hold reset sleeve while inserting fasteners.)
If the fastener assembly cannot be inserted into the muzzle, do not force the
fastener into the muzzle. This can jam the fastener in the tool and damage
the fastener. Fasteners that cannot be inserted should be removed and
discarded appropriately.
In case of jammed fasteners – Refer to the Troubleshooting Guide (Page 11) for
proper removal of all jammed fasteners.
3.
Place the NITROSET® tool perpendicular against the fastening surface.
Cracked concrete may actuate loudly when using the tool.
Fasteners should not be driven close to the edge of the base
substrate.
Always maintain a distance of at least 3" from the concrete
edge or 1" from the steel edge.
W W W . N I T R O S E T . C O M
7
Too close to edge