AquaPRO 63043 Guia De Inicio Rapido

Quick Start Guide
Convertible Jet Pump with 6 U.S Gallon Tank
SHALLOW WELL APPLICATION (0-25 FT.)
1. Assembly the tank with pump together. Connect a rigid pipe to the
foot valve. Connect the tee to the pipe, and slide the pipe assembly
into the well. Connect the pipe assembly with pump and connect the
pump with water system.
Pipe
Priming tee and plug
Check valve
Flexible plastic pipe
and clamps
Priming Tee
and Plug
Well Seal
25 ft max.
Pipe
10 ft min.
Foot Valve
Strainer
5 ft min.
3. Prime the pump and pipe.
Model# 63043
DEEP WELL APPLICATION (25-70 FT.)
1a. Removing the pre-assembled ejector first then
removing the pre-assembled nozzle and venturi.
Install the included nozzle and venturi for deep well
application.
4. Voltage setting
• This pump is pre-wired at 230 volts.
• If the power source is 115 volts, remove the
electrical housing cover.
• Flip the switch to 115 volts. Replace the cover.
electrical housing cover
Read your manual for installation, operation, and safety information.
This guide neither supplements nor replaces the Owner' s Manual.
1b. Assembly the tank with pump together. Connect the
foot valve to the ejector. Connect the rigid pipe to the
ejector and slide the pipe assembly into the well.
Connect the pipe assembly with the pump. Connect the
pump with water system.
1 in. PVC Adaptor
Flexible plastic pipe
and clamps
Priming tee
and plug
Elbow
Well seal
70 ft max.
Pipe
Nipple
Ejector (included)
Foot valve
Strainer
5. Connect the power supply wiring to the pressure switch.
• Remove the pressure switch cover on the pump to expose the wiring terminals.
• Connect the green ground wire of the power supply to the switch ground terminal.
• Connect the power supply wires to the two outside terminals marked "LINE" and
replace the switch cover.
Power supply
and LINE
Ground connection
must be made at this point
3/4 in.x 1 in.adaptor
Pressure regulator(included)
10 ft Min.
5 ft Min.
1
2
To motor lead
and LOAD