Air Filter - POLTI Climate FA 15 CS Manual De Instrucciones

When the air conditioner does not work, it is sometimes a minor problem which the user can ea-
sily deal with himself.
Before calling the After Sales Service, you should check the following points and see if you can
solve the problem by yourself.
PROBLEM
The air conditioner does not
work
Poor performance
The air conditioner makes a
bubbling noise
Water leak
Motor noise when the
appliance is turned off
CLEANING
Before cleaning and maintenance operations, turn off and unplug the unit.
For safety reasons, never wet the air conditioner.
EXTERIOR SURFACES OF THE APPLIANCE
• Clean the air conditioner by using a damp sponge, and dry it with a clean cloth afterwards.
• Never use petrol, alcohol or any product containing solvents.

AIR FILTER

The air filter collects the dust contained in the air so that dust does not clog up the appliance,
your FA15CS must always be used with its air filter.
The build-up of dust reduces the efficiency of the air conditioner. Against this, the air filter needs
to be cleaned fortnightly or more often if the unit operates in a dusty atmosphere.
• Remove the filter by lifting it slightly to disengage it and pull it downwards.
• Clean the filter with a vacuum cleaner. If the filter is very dirty, you can wash it in warm water.
Make sure that the air filter is completely dry before replacing.
ENGLISH
T T R R O O U U B B L L E E S S
T T R R O O U U B B L L E E S S
PROBABLE CAUSES
• no electrical supply
• plug not properly inserted
in socket
• button I/O not pressed
• 3 minutes delay
• wrong selection of the
mode
• air filter blocked with dust
• the cooling agent
circulates in the circuits
• the outside unit is placed
higher than 1,60 m from
the bottom of the inside
unit
• automatic operating of the
pump to evacuate the
water of condensing
M M A A I I N N T T E E N N A A N N C C E E
M M A A I I N N T T E E N N A A N N C C E E
H H O O O O T T I I N N G G
H H O O O O T T I I N N G G
SOLUTIONS
• wait and check the fuse
• plug the appliance properly in
• press the button I/O
• wait for 3 minutes
• select the correct function
• clean the air filter
• this is normal
• place the outside unit lower
as shown on picture 3
• this is normal
O O F F F F A A 1 1 5 5 C C S S
O O F F F F A A 1 1 5 5 C C S S