flow-med dry-cap uv 2 Manual De Instrucciones página 4

EN INSTRUCTION MANUAL
Dry&Clean Mode (2 h)
The Dry&Clean mode is an automatic program and combines
fast drying with an efficient fan with UV-C light at the begin-
ning and end of the drying time for perfect hygiene.
Using first time
1. Plug the USB cable into a USB socket of the dual-port USB power supply and the round plug into the socket on the back
of your dry-cap uv 2®. You can plug the USB cable of the charging station into the second USB socket.
2. Then plug the power supply unit into a mains socket.
Operation Dry&Clean Mode (2 h)
3. Place the dry-cap uv 2® with the acrylic hood over the charging station with the rechargeable hearing aids.
4. Press the left button (Dry&Clean mode) and the care program (drying + UV-C) starts automatically.
• The fast drying by fan is controlled by a microprocessor
and runs for 2 h
• Ultraviolet light (253,7 nm) eliminates germs and bacteria
to 99.9% within 2 min
• After 2 min the UV-C light switch off automatically,
the drying process continues
• Within the last minute of the 2 h drying program,
a second UV-C hygiene runs
• After 2 h the dry-cap uv 2® automatically shutdown to stand-by
Drying and hygiene are complete, the charging of the hearing aids in the charging station continues and can
remain under the dry-cap uv 2® after the charging station is switched off.
5. Lift the dry-cap uv 2® up and off next to the charging station. Remove the dried and hygienically cleansed hearing aids
from your charging station.
Clean Mode (2 min)
The Clean Mode is a short-term hygiene program and starts
the optimized UV-C light, which effectively eliminates up to
99.9% of germs, bacteria and fungi present in the household.
i The dry-cap uv 2® is ready to use
i LED permanent light
i LED blink light
i LED permanent light
i LED blink light
i LED switch off
2