Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation

NOTE:
Control panel can be accessed at upper-right corner of insert (I). When a function is changed from the
control panel or remote control there will be a corresponding indicator (see Figure 1) on the upper-right of the
projection screen. The indicator shows the function changed and the level selected by the control panel or remote
control. When the function is turned off, the corresponding indicator will flash several times and then fade off.
1
Power
Push the power button to supply power to all
functions of the fireplace and put the insert in a
standby mode.
Push the power button again to turn off all functions.
NOTE:
All previous settings are held in memory, so the
next time you power up the fireplace, the unit will turn on
with the same settings.
NOTE:
Holding the POWER button on the control panel for
10 second will disable the heater function.
3
Heater
Press the heater button to set the thermostat. Your
fireplace consists of a fan-forced wire-element-type
heater. The thermostat setting range is 62°F - 82°F or
17°C - 27°C or always ON.
This button on the remote control only turns ON and
OFF heater function.
NOTE:
To change between °F and °C press and hold the
heater button on the control panel for 10 seconds.
2
Flame
Press the flame button to increase and decrease the
flame intensity. There are 6 brightness levels you can
cycle through as well as the OFF setting.
4
Timer
Press the timer button to cycle through the 10 timer
settings (30 minutes, 1 Hour, 2H, 3H, 4H, 5H, 6H,
7H, 8H and 9H) and the OFF setting.
10
°
C
°
F
Fig . 1

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

000 000

Tabla de contenido