Earth Wise SN74014 Manual Del Operario página 11

Auger (Fig. 8, 13)
CAUTION Check fasteners before each use. A
loose auger can result is excessive vibration and
damage the snow thrower.
To replace the auger:
1. Remove cover (8) and friction plate (16). Remove
bolt (15), washer (14), fix plate (13), and drive belt
(6).

Loosen the nut (24) from the other side of the auger
(18) and dismount the pulley (12) and auger axle
(19).

Replace the auger with a new one.
13
14
MAINTENANCE AND STORAGE
17
4. When reassembled ensure all screws and nuts are
properly tightened.
Scraper blade (Fig. 14)
The scraper blade is a wear item and should be replaced
when necessary. A worn scraper blade can cause
extreme vibration and damage the auger.
To replace the scraper blade:
1. Remove the three screws from the bottom of the
blade and slide the blade forward to remove.
2. Install new scraper blade.
3. Secure with the three screws.
4. Ensure the screws are properly tightened.
11