HIKVISION DS-PD2-T12AME-EL Manual Del Operador

DS-PD2-T12AME-EL
EN50131-2-4:2008
EN50131-1:2006+A1:2009
Security Grade (SG) 2
This product and - if applicable - the supplied accessories too are marked
Environmental Class (EC) IV
with "CE" and comply therefore with the applicable harmonized European
2011/65/EU.
For electrical products sold within the European Community. At the end of the
electrical products life, it should not be disposed of with household waste.
for recycling advice in your country.
Diagram Reference
Ensure that the detector is installed away from reflected sunlight and objects.
2. Switches
Switch Down
1 AC 230V, 50 Hz AC 110V, 60 Hz
2
3 Blocking off Blocking on when disarmed
4 R1 off R1 on
5
6 Open mask & alarm relays Open mask relay only
7 Buzzer on Buzzer off
8 LEDs on LEDs off
If you disable the detector's LEDs, you can remotely enable them in walk tests. Connect the
detector's LED terminal to a control panel PGM output that switches to 0V to enable the LEDs.
4. LEDs
Four LEDs show the status of the detector.
5. Lens inserts
Use lens inserts to control coverage.
6. Header pins
P lace two-pin jumpers onto header pins to adjust resistance for alarm, masking/fault and tamper.
highlighted dial to change the masking area range. When an intruder enters the masking area,
LED2 pulses. When the intruder moves out of the masking area, if the detector does not see
8
To connect the detector to CCTV and lights, refer to the wiring diagram.
Detectors Detectors
Blue Wave Technology Yes
Maximum Range 12m
Digi Logic Technology Tri-detec on logic
Volumetric Coverage 90° coverage
Automa c Yes
Animal Immunity Up to 24kg | 1 - 1.5m (moun ng height of detector)
Set Auto or high
Tri Technology Yes
Digital Yes
Detec on Speed 0.25 - 2.5 m/s
Dual Element Pyro-Electric Sensor Yes
Detec on Zones 2 x22 zones
DEOL Resistor on Board Tamper, alarm and mask
Detec on Planes 2
Tamper Front, and rear
Adjustable ( ) 0 - 1m tri-masking covering all 3 technologies
Intergrated Walk Test Buzzer Yes
Protec on Tri-an -masking technology | IP55 rated
Separate LED Indica on Yes
Lens UV compensated
Digital Independent Yes
Standard Yes Op cs Dual-Vision Sealed Op cs
Frequency Range 10.515/10.525/10.535 GHz Detec on Method Tri-signal detec on logic
An -Sway Yes An Blocking Technology Yes
Waterproof Yes Sensor 2 low noise dual element passive infrared sensors
Casing 3mm polycarbonate, 0.4mm HDPE in lens area Moun ng
Electrical
Wall Mounted Yes - addi onal wall and fixed brackets available
Opera ng Voltage 9-16VDC, 12VDC typically
Op mum Coverage Height 1-1.5m
Supply Current 67mA @ 13.8VDC quiescent
Environmental and opera ng features
Relay Outputs 3 x SELV limits, 60VDC ~50mA (42.4VAC peak)
-25 °C to 60
Tamper Switch 12VDC 50mA both front and rear
Physical Dimensions (H × W × D) 188 × 77 × 84 m m
Weight 300 g
!
The Input voltage should meet both the SELV (Safety Extra Low Voltage) and
the Limited Power Source according to the IEC60950-1 standard. Please refer
to t ations for detailed information.
COPYRIGHT ©2018 Hangzhou Hikvision Digital Technology Co., Ltd.
ALL RIGHTS RESERVED.
wholly, by any means, without the
About this Manual
This manual is applicable to detector.
other reasons. Please find the latest version in the company website
Please use this user manual under the guidance of professionals.
Trademarks Acknowledgement
1
12m
2
12m
2
4
LED 1 LED 2 LED 3
This product operates in a
European non-harmonised
frequency band
LED 4
Hangzhou Hikvision Digital Technology CO.,Ltd.
1-1.5m
< 24kg
1-1.5m
1m 1-1.5m
4m 8m 12m
3
1-1.5m
12m
ON
0m
5
T vated
vated
Microwav vated
Alarm
Masked / blocked
Mask processing
Powering up
Low voltage
Top PIR failed self-test
failed self-test
Microwave failed self-test
No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
< 10m
1-1.5m
4m 8m 12m 4m
> 10m
1-1.5m
4m 8m 12m 4m
12m
~8m
2 2
8m 12m
8m 12m
1.3m
1.3m