EarthWise LCS34014 Manual Del Operador página 5

INSTALLING/REPLACING THE GUIDE BAR AND CHAIN
DANGER: Never start the motor before installing the
guide bar, chain, chain cover and chain cover lock knob.
Without all these parts in place, the clutch can fly off or
explode, exposing the user to possible serious injury.
WARNING: To avoid serious personal injury, read and
understand all the safety instructions provided.
WARNING: Before performing any maintenance, remove
the battery pack from the saw. Failure to heed this warning
could result in serious personal injury.
CAUTION: Always wear gloves when handling the bar and
chain; these components are sharp and may contain burrs.
WARNING: Never touch or adjust the chain while the
motor is running. The saw chain is very sharp; always wear
protective gloves when performing maintenance to the
chain to avoid possible serious lacerations.
NOTE: When replacing the guide bar and chain, use only
identical replacement parts.
WARNING: Remove the battery from saw.
● Loosen the chain saw lock knob counter clockwise.
(Fig.3)

Remove the chain cover. (Fig 4)
● Remove the bar and chain from the mounting surface.
(Fig 5)

Remove the old chain from the bar.

Lay out the new saw chain in a loop and straighten any
links. The cutters should face in the direction of the chain
rotation. If they face backwards, turn the loop over. (Fig
6)
Fig.3

Place the chain drive links into the bar groove.
NOTE: Make certain of the direction of the chain.

Position the chain so there is a loop at the back of the
Fig 4
bar.(Fig 7)
5
Fig 5
Fig.6
Fig.7