Publicidad
Idiomas disponibles
Idiomas disponibles
8. Cleaning and Care
Unplug the power cord from the mains outlet. Clean the motor unit using a
slightly dampened soft cloth. Caution! Do not use liquids to clean the motor
unit and the power connections. Do not use any aggressive, strong or abrasive
cleaning agents.
You can clean the blender jar, the lid and the blade unit in soapy water. The
blender jar and lid can also be cleaned in the dishwasher at low temperatures.
To clean the appliance quickly and immediately after use, fill the blender jar with
warm water up to about 60%, add some detergent and let the appliance run
briefly. Then remove the blender jar and shake it slightly. Make sure that you do
not shake too much, otherwise the liquid can come out of the bender jar. Finally,
rinse the blender jar and the blade unit with clean water until all the residues and
detergent are removed.
Allow all parts of the appliance to dry completely!
9. Troubleshooting
Error
Cause
The appliance
• 1. Voltage is too low
stops during
• 2. Thermal fuse has
the operation
The blade unit
• Blade unit is stuck be-
is stuck
Unusual
• The blade unit was not
sounds
• The appliance was not
• The voltage is too high.
• Excessive content in the
English
tripped
cause of the contents
mounted properly.
placed on a flat surface.
appliance.
Possible rectification
• Check the power supply
• Allow the appliance to cool for
20 to 30 minutes and try again
• Switch off the appliance and
disconnect the mains plug.
Wait till the appliance stops
completely and then remove
the content, which is blocking
the blade unit.
• Mount the blade unit properly.
• Place the appliance on a flat
surface.
• Check the power supply
• Switch off the power, remove
the additional content.
29
Publicidad
