Assembly - MTD CL25HT Manual Del Operador

WARNING:
DO NOT USE an extension boom with this
product. It is not designed to be used with an extension
and using one may cause serious injury.
WARNING:
Do not use this attachment with an electric
or battery-powered unit. Doing so could cause the motor
to overheat, resulting in damage to the unit and possible
personal injury.
OPERATING THE COUPLER
The coupler enables the use of various optional attachments.
WARNING:
Before using any attachment, read and
understand the manual that came with the attachment.
Follow all safety information contained within.
WARNING:
To avoid serious personal injury and
damage to the unit, shut the unit off before removing or
installing an attachment.
NOTE: To make installing or removing the attachment easier, place
the unit on the ground or on a work bench.
Installing the Attachment
NOTE: Remove the protective cap and gray spacer from the upper
and lower shafts prior to assembling the attachment.
1. Turn the knob counterclockwise to loosen (Fig. 1).
2. While firmly holding the attachment, push it straight into the coupler
until the release button snaps firmly into the 90˚ hole (Fig. 3).
3. Turn the knob clockwise to tighten (Fig. 1).
CAUTION:
Before operating the unit, make sure the
release button is fully snapped into the 90˚ hole (Fig. 3) and
the knob (Fig. 1) is securely tightened. Using the wrong
hole could lead to personal injury or damage to the unit.
Removing the Attachment
1. Turn the knob counterclockwise to loosen (Fig. 1).
2. Press and hold the release button (Fig. 2).
3. While firmly holding the upper shaft housing, pull the attachment
straight out of the coupler (Fig. 3).

ASSEMBLY

90˚ Hole
Coupler
90˚ Hole
Upper Shaft
Housing
6
Knob
Fig. 1
Release Button
Fig. 2
Lower Shaft
Housing
Fig. 3