Installing The Rack Stabilizer Feet - Dell PowerEdge 2420 Guia De Instalacion

Installing the Rack Stabilizer Feet

WARNING:
installed could cause the rack to tip over, potentially resulting in bodily injury
under certain circumstances. Therefore, always install the stabilizer feet before
installing components in the rack.
Installing the Front Stabilizer Feet
1 Open the front door.
2 Reach into the rack and pull up firmly on each stabilizer to detach
them from the frame.
3 Remove the plastic fasteners attached to the stabilizer feet.
4 Position each front stabilizer foot against the base of the rack frame
and align its holes with the corresponding holes in the frame.
5 Use the provided bolts, washers, and cage nuts to secure each foot
to the rack as shown in Figure 1-11.
Figure 1-11. Installing the Front Stabilizer Feet
1
20
Installation Guide
Installing systems in a rack without the front and side stabilizer feet
1 front stabilizer foot (2)