STERWINS DRP-2 Manual Del Usaurio página 64

- If the outlet of your pump is with female thread, please follow 1-3 steps
directly.
- If the outlet of your pump is with male thread, firstly you should screw the
adaptor(10) onto the outlet of your pump, then follow 1-3 steps.
1. Connect the water inlet (3) to the pressure connector of pump (11). (Fig. 5)
-Hold the main body(9), turn off crew(8) and water inlet(3). (Fig.2)
-Hold screw(8), turn water inlet(3) separately into pressure connector(11). (Fig.4)
-Put main body(9) on the screw(8), hold main body(9), and turn screw(8) in anti-clockwise
direction, make sure tight connection between main body(9) and screw(8). (Fig.5)
2. Insert the power plug(12) of pump into extension socket (5).(Fig.6)
3. Now it is the time to connect the pump with suction hose, and connect the discharge hose
to the water outlet(4).
Operation:
1. Insert the power plug (6) into the mains.
2. Turn on the pump switch.(The red warning indicator light (2) on ).
3. Push start-up button (1), the pump motor running. Please don't release the button before
pump delivered water out and keep works normally. Release button when the red warning
indicator light (2) off.
4. When the pump is without water supply, the red warning indicator light (2) is on, and dry
running protector will switch off pump automatically.
EN - 3