Reversing The Door Swing - AMERICANA 15 Manual Del Usaurio

1
INSTALLING THE WATER LINE
11
PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.
2

REVERSING THE DOOR SWING

IMPORTANT NOTES
When reversing the door swing:
• Read the instructions all the way through before
starting.
• Handle parts carefully to avoid scratching paint.
• Set screws down by their related parts to avoid using
them in the wrong places.
• Provide a non-scratching work surface for
the doors.
IMPORTANT: Once you begin, do not move the
cabinet until door-swing reversal is completed.
These instructions are for changing the hinges from
the right side to the left side—if you ever want to change
the hinges back to the right side, follow these same
instructions and reverse all references to left and right.
16
Installation Instructions
(CONT.)
START THE ICEMAKER
12
On power switch models, set the icemaker power
switch to the l (on) position. On feeler arm models,
move the feeler arm to the ON (down) position. The
icemaker will not begin to operate until it reaches
its operating temperature of 15°F (–9°C) or below.
It will then begin operation automatically.
Power
switch
Power switch model
Feeler arm model
NOTE: In lower water pressure conditions, the
water valve may turn on up to 3 times to deliver
enough water to the icemaker.
TOOLS REQUIRED
Phillips screwdriver
5/16" hex-head
socket driver
Putty knife or thin-blade
screwdriver
Feeler Arm in the
STOP (up) position
Feeler Arm in
the ON (down) position
Masking tape
T20 or T25 Torxdriver,
(needed for some
models)
5/16" open-end
wrench