Preparing The Machine; Handling The Packaged Machine; How To Unpack The Machine; Battery Installation/Connection - BETCO GENIE APS B Manual Uso Y Mantenimiento

1. HANDLING THE PACKAGED MACHINE

The machine is contained in specific packing.
Each pallet contains four machines placed on two levels.
More than two packings cannot be stacked.
Total weight is 70 kg.
Overall dimensions are:
A : 500mm
B : 500mm
C : 1150mm

2. HOW TO UNPACK THE MACHINE

1. Open the packing on the side indicated
2. Remove the machine from the packing
3. Pull our the recovery tank

3. BATTERY INSTALLATION/CONNECTION

The machine is supplied with battery charger and sealed gel batteries. In case of using different
batteries from those supplied with the machine, use only batteries 12V AGM or Gel and proceed as
follows:
The batteries must be housed in the battery compartment located under the solution tank.
To install the batteries you must:
1. Remove the solution tank
2. Open the two rear hinges that close the battery compartment
3. Rotate the handlebar by lifting the handlebar control lever (see: "FASTENING THE
HANDLEBAR")
4. Place the battery in the compartment
5. Connect the cables
ATTENTION: We recommend using exclusively sealed batteries to avoid
acid spillage.

PREPARING THE MACHINE

8