Count Of Operations; Child Lock; Return To Factory Setting - Royal Sovereign RCMW1000-25SS Manual Del Propietário

X2 function can only program one stage cooking. After setting is finished, press STOP/RESET to return to waiting mode. The oven will start
after you touching X2, any of the number keys and then the START pad.
For example, to use the X2 function, and save a program of full power and 3 minutes cooking to number pad 8.
1. Touch PROGRAM once.
2. Touch X2 pad once.
3. Press number pad 8.
4. Press POWER LEVEL once.
To Test the programming just completed
i. Touch X2 Pad Once
Note: If you want the oven to start immediately after you touching any of the number keys instead of after you touching the START pad,
press and hold down STOP/RESET for 5 sec until "P L" appears on display; now you don't need to press START pad after selecting
a cooking program by touching any of the number keys.

COUNT OF OPERATIONS

You can read the count of how many times the oven has been used. To do this,
1. In waiting mode, press and hold down STOP/RESET.
2. Touch POWER LEVEL pad. The number on display shows how many times the oven has been used.
This function is for the user to analyze the usage of the oven and the traffic flow at a particular location where the oven is being used
commercially.

CHILD LOCK

In waiting mode, press and hold PROGRAM for 5 seconds. The oven is locked.
To release child lock.
Press and hold PROGRAM for 5 seconds, the oven goes to normal.

RETURN TO FACTORY SETTING

If you want the oven return to the default factory setting, you can press Start pad and plug in the oven until "00:00" shows on the screen,
then press the following pads one by one : "1", "2", "3", "4", "5", "6", "7", "8", "9", "0", "Power Level", "X2", "Program", "Stop/Reset"
and "Start". And the screen will show "00:15", open and close the door, then open it again. Beep will be heart to signal to oven is back to
factory setting.
5. Touch number pads 3, 0, 0.
6. Press PROGRAM to save.
7. Press STOP/RESET button
ii. Touch Number pad 8
13
RCMW1000-25SS
iii. Press START