SentrySafe SFW123BDC Manual Del Propietário página 11

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5
Move the safe aside to clear both marked spots for drilling.
6
Drill into the floor:
Replace the safe in the desired position, with the holes in the safe aligned with
7
those in the floor.
8
Securing the safe:
F
F
F
NOTE: The safe should not be bolted to a wall, this will compromise the fire rating.
Drill holes through the feet only. Do not drill through the back or sides.
NOTE: Bolting/unbolting the unit is at the consumer's expense and discretion.
NOTE: Sentry Group is not responsible for any costs incurred if the unit is to be replaced.
For products that do not come with a bolt down kits.
Go to www.sentrysafe.com to find recommended hardware and instructions.
For wood: Using the
" drill bit, drill a hole 2
A
9
32
(64 mm) deep in each marked spot.
For masonry: Using the
B
3
(64 mm) deep in each marked spot. Install a masonry
anchor in each hole.
For wood: Pass each lag screw through a washer,
A
then through the safe and into a hole. Tighten with
the wrench.
For masonry: Pass each lag screw through a washer,
B
then through the safe and into a masonry anchor.
Tighten with the wrench. Place masonry anchors into
the holes in the floor.
11
"
1
2
" drill bit, drill a hole 2
"
1
8
2

Publicidad

Tabla de contenido
loading

Tabla de contenido