SentrySafe SFW123BDC Manual Del Propietário página 5

3
Locking your safe
1
2
Programming your user code
To ADD a user code:
Press the "PROG" key.
1
Enter the 5 digit factory code.
2
The light will flash green and then you will have 30 seconds to enter your own
3
personal user code. This code must be 5 digits.
To DELETE a user code:
Press the "PROG" key.
1
Enter the 5 digit factory code.
2
Enter 0,0,0,0,0.
3
NOTE: The electronic lock will NOT indicate that it has deleted the user code –
please test the code to make sure it has been deleted.
NOTE: Delay mode will occur if three consecutive invalid entries have been tried. The red light
will blink during delay mode. This will cause the system to shutdown for two minutes.
Do NOT remove the batteries to restart the system – it will only increase the length of
time for the system shutdown.
Rotate the handle downward to open the door.
This may take a limited amount of force because you
have a water resistant safe.
Close the door and pull the handle upward until the handle
is horizontal.
For water resistant units, additional pressure to the front,
left side of the door may need to be applied prior to rotating
the handle.
Turn the key to the unlocked position and remove the key.
Push in the keylock plunger. If the keylock plunger is not
pushed in, the safe will not be fully locked.
5