Attaching Adapter Plate To Projector - peerless-AV PAG-UNV Instalación Y Ensamblaje

Attaching Adapter Plate to Projector

NOTE: The projector you are installing may differ in appearance from the sample illustrated below.
Place projector upside down. Locate adapter plate (D) with notch facing forward as close to projector center of
4
gravity as possible without covering any mounting holes. Loosen channels, and if there are only three mount-
ing holes remove fourth channel. Using one channel for each mounting hole, position feet of channels over
mounting holes as shown below. IMPORTANT: If projector does not have at least three mounting holes, do not
use this adapter plate.
NOTE: Some projectors have feet which can be removed and the corresponding threaded insert can be used
for a mounting hole.
NOTE: Once channels are in position retighten fasteners.
Notch indicates front
of projector
Attach adapter plate (D) to projector using one screw (E, F, G, or H) for each channel as shown below. Tighten
5
all screws, while keeping the center of gravity. Be sure that adapter plate (D) is straight. Adjust the feet of the
channels to keep the adapter plate level. Tighten all screws with 4 mm security allen wrench (O) or wrench
provided with projector mount, while keeping the center of gravity. If M3 screws are used, tighten using 2 mm
security allen wrench (I).
NOTE: Projectors will require different size screws for mounting. Use a combination of screws (E, F, G, or H)
and foot adjustment that will result in channels of adapter plate (D) fitting tightly against projector.
IMPORTANT: In order to properly engage the threads in the mounting holes, the screw must be turned at least
3 full turns.
NOTE: If using screw (E), place washer (J) between screw (E) and foot of channel.
CAUTION
• It is the responsibility of the installer to ensure that
the projector is properly ventilated. Feet of channels
are used to raise the mount off the projector surface.
Mounting
hole
Generic Projector
8 of 27
D
D
Foot of Channel
ISSUED: 08-13-09 SHEET #: 056-9023-7 09-10-12
E, F, G,
or H