Setting Thermostat - peerless-AV FPE47F-S Instalación Y Ensamblaje

Setting Thermostat

Refer to display manufacturers' requirements for optimal environment temperature. If display manufacturer's
8
requirments state that cooler or warmer temperatures are acceptable, use a fl atblade screwdriver to adjust dial to
desired temperature.
NOTE: Thermostat inside enclosure assembly will determine at what time the Exhaust Fan will initiate. The Intake
Fan will operate at all times. For all other questions, refer to thermostat instruction sheet included in enclosure
assembly.
HEATER INFORMATION (FPE47FH-S,FPE55FH-S only)
Thermostat of heater is not adjustable. The heater will turn
on at 40°±7° and will turn off at 60°±5°.
Heater uses a 20 amp fuse.
WARNING
• Frame of heater will be hot when turned on. Turn
heater off allowing frame to cool prior to service.
CAUTION
• Do not postion AV and power cables close to heater
or damge to cables may occur.
THERMOSTAT
DIAL
14 of 50
ISSUED: 07-12-10 SHEET #: 061-9056-8 03-05-13
HEATER