Mounting Flat Panel Screen With Vesa Hole Pattern - peerless-AV SP850 Instalación Y Ensamblaje

Place installation tab over sliding arms of wall mount assembly (A) to lock them in place.
3
FOR INSTALLING TO VESA 100 MM, 200 MM HOLE PATTERN
• If screws don't get three complete turns in the screen inserts or if screws bottom out and adapter plate is still not
tightly secured, damage may occur to screen or product may fail. Contact customer care for correct hardware to
use.
®
Find the VESA hole pattern as shown in fi gures 4.1 and 4.2, and attach screen to mounting plate as specifi ed
4
below. Verify that all holes are properly aligned, and then tighten screws. If using security screws, tighten using
security allen wrench (M).
FOR VESA 100 MOUNTING PATTERN:
Thread two M4 x 12 mm screws (BB), leaving .25" exposed thread, into top holes on back of screen. Hook screen
onto mounting plate, and attach using bottom two M4 x 12 mm screws as shown in fi gures 4.3 and 4.4. (page 7)
Tighten all four screws.
Note: If screw (BB) is too small to engage threaded inserts, attach mounting plate to back of screen using
four M5 x 10 mm screws (AA).
INSTALLATION TAB
SLIDING ARM
A
WARNING
VESA 100
fi g. 4.1
6 of 21
VESA 200
fi g. 4.2
ISSUED: 10-12-05 SHEET #: 202-9038-9 06-29-11